|
Post by jnmodeller on Dec 8, 2012 14:52:50 GMT 8
One day my trusty AGM Mp40s pot metal just gave in. Just like Dr. Frankenstein cant accept loosing it. Just want to share how i revive her. hope this helps. Glue this broken part using Devcon, floding it with adhesive on the inner side of it. Replicate the broken part using your aluminum bar.  Length should reach at list one side of the trigger guard for a better support. Drill a hole for a little screw to hold it tighter. Aluminum is a soft metal so bending would not be a problem.  Ddry fit first for any adjustment needed   Use a metal bit to grind surface rough for better adhesive  As shown on this pic below  apply Devcon  Use clam to secure and leave it over night. I spotted another crack and applied Devcon from the inside.    note , Sand the excess glue and aluminum with no.600 before painting. Now shes Alive!  by Bong Manayon
|
|
|
Post by genemilioaguinaldo on Dec 10, 2012 16:44:23 GMT 8
great job!
|
|